2019 Seawind 1160 Lite

• Aluminium Hatches & portholes (9 in total) 
• All upgraded with privacy shades
• 4 x Forward Hatches 470mm x 470mm
  2 x Mid cabin hatches 470mm x 470mm
  1 x Port Bathroom window hatch 507mm x 377mm
  1 x Galley window hatch 507mm x 377mm
  1 x Aft Cabin window hatch 507mm x 377mm
• Fibreglass Deck Hatches:
  5 x Forward anchor & storage hatches.
  2 x Cockpit engine access hatches.
• 6 x Docking cleats. Each side : bow, stern & amidships.
• 6x Safety handles around cockpit.
• 1 x Heavy duty mooring cleat on forward walkway.
• Ventilation: 2 x forward cabin hatch vents.
• Mast base turning blocks. All halyards & sail controls to cockpit.
• 9 x Rope clutches.
• Sheet winches : 1 x 45ST – 2 speed self tailing, 2 x 40ST – 2 speed self tailing - Added Lewmar 45 electric winch
• Stanchions/Rails: High quality stanchions, bow rails and stern rails with 3 life-lines. With 700mm high lifelines to meet CE requirements.
• 2 x transom access gates with pelican hook releases.
• 2 x side access gates with pelican hook releases.
• Aft swim ladder: folding stainless aft swim ladder.
• Cockpit refrigerator

INTERIOR FINISH:

• New Lightweight interior redesign.
• Furniture and cabin sides gloss gelcoat finish.
• Cabin top lined with light weight internally molded gelcoat liner.
• New Floors: synthetic timber flooring.
• New Lightweight cupboard doors and trimmings

SALOON:

• New Lightweight grp saloon table
• Upholstered settee.
• New Lightweight grp coffee table
• Forward aluminium opening windows.
• Saloon side windows in 8mm toughened glass.
• Tri folding cockpit doors
• Removable low profile, helm hatches.

SLEEPING CABINS:

• Light weight pvc foam cored timber doors on all private cabins.
• Port & Starboard fwd cabins : Each queen sized bed (2050mm x 1540mm)
• Aft Starboard cabin : Double bed (1990mm x 1230mm)
• Mattresses 150mm ( 6” ) foam upholstered. Owner's cabin mattress upgraded to pillow top latex, custom made
• Cabins lined.
• 12volt LED lighting.
• Storage/Cupboards.

PORT HEAD:

• Polished light weight pvc foam cored timber door.
• Polished light weight pvc foam cored timber door.
• Electric toilet. Discharge via holding tank.
• Holding tank built in. Discharge pump out by shore station or directly overboard 130L.
• Pipes, skin fittings and sea-cocks are easily accessible and to meet survey requirements.
• Vanity basin with pressure water.
• Separate shower stall with wall mounted shower head & mixer tap.
• Electric shower bilge pump with direct overboard discharge.
• Large quantity cupboards / shelves to very high quality

• Spacious galley with co-ordinated Polystone counter surfaces.
• Three (3) burner LPG stove, stainless steel pot holders. Flame failure device to shut off LPG immediately in event of flame going out.
• Oven with broiler
• Double bowl stainless steel sink.
• Pressure fresh water system.
• Filtered water tap
• Upgraded Refrigerator: Front opening upright fridge - stainless
• Under bench storage
• Trash bin.
• LPG solenoid control in galley
• Expanded cooling plate in bench freezer, providing even freezing

Yanmar 29Hp diesels with saildrives

• High quality DC electrical switch panel with circuit breakers, LED indicator lights and voltage display.
• Marine grade tinned electrical wiring with extensive use of heat sealed connectors..
• Batteries x 3 comprising: House System (540 amp hrs) : 2 x 270 amp hr heavy duty batteries. One  engine cranking battery – 130 amp hr heavy duty battery.
• BATTERY CHARGER / INVERTER: MASTERVOLT 2600W/100AMP 110V 
• SOLAR PANEL UPGRADE FROM 2 X 125W TO 4 X 200W & MPPT CONTROLLER
• 230amp heavy duty isolation switch.
• 12 V lighting : Numerous 12V interior lamps and courtesy lights throughout including recessed lights in cockpit.
• 4 x 12V Outlets.
• CE approved navigation lights. Port & Starboard mounted on bow rails.
• Deck floodlight mounted on spreaders.
• Mast head anchor / riding light.

• Clear anodised aluminium mast and boom. Single Spreader, 7/8 rig.
• Standing Rigging:
  – Forestay 3/8 (10mm) 1 x 19 Dieform wire.
  – Sidestays 3/8 (10mm) 1 x 19 Dieform wire.
  – Diamonds 5/16 (8mm) 1 x 19 Stainless Steel wire.
• Halyards:
  – Main halyard: 12mm Spectra rope : Heavy duty shackle.
  – Jib halyard: 8mm Spectra rope. Heavy duty shackle.
  – Topping lift: 8mm rope. Heavy duty shackle.
  – Boom outhaul: 10mm Spectra.
• Single line reefing, run to helm. Three reefing points with 2 reef lines:
  – Reef 1&3: 10mm rope. Leech/Clew blocks and snap shackle.
  – Reef 2: 10mm rope. Heavy duty shackle.
• Sheets:
  – Main sheet: 10mm rope
  – Main traveller control: 10mm rope
  – Jib sheet: 10mm rope
• All halyards, reefing lines to be lead back to cockpit through turning blocks, rope clutches.
• Fully battened mainsail. Triple stitched reinforced construction. Leach adjustable batten end caps. Fibreglass sail battens.
• Mainsail cover with integrated lazy jack system.
• Self-tacking headsail, curved headsail traveller track with end stops. With New single line control sheet to cockpit.